| 7. Move the sliding way to the traveling end at any side and slightly lock pre-stressed adjustment screw above the roller retainer. (figure 3-5) |
 |
| 8. Move the sliding way to the traveling end at the other side and slightly lock pre-stressed adjustment screw. (figure 3-6) |
| 9. Move the sliding way to the central position and slightly lock the adjustment screw at the central position (figure 3-7). |
| 10. Repeat operations from (7) to (9) until there is no gap in horizontal direction. Caution against applying excessive pre-stressed loads. |
| 11. Once there is no gap in the horizontal direction, the dial deflection on the gauge is minimal and stable when the sliding way is moved horizontally; at this time carry out final calibration of the pre-stressed loads by repeating operations from (7) to (9) using the torque force recommended for locking screws. |
| 12. Tighten the gonio way d which is temporarily locked in the sequence for locking pre-stressed adjustment screws. |
♦ Torque force recommended for locking screws
| unit：N.m |
| Models |
values of locking
torque force |
| M2 |
0.3 |
| M2.5 |
0.6 |
| M3 |
1.3 |
(stainless steel screws) |
